The Maxamizer is a computer controlled, low pressure airless spray system that dispenses lubricant from as many as twelve nozzles. A LSP computer controls the spraying of the lubricant and can be located remote from the dispensing manifold, and the nozzles can be located up to 8’ away from the dispensing manifold. Ideal for large dies, transfer dies, roll formers and other types of metalforming equipment.


The MaxaMizer allows the setup person to setup the
lubricating of each die in a manner of minutes. The
spray nozzles can be positioned with strong magnets and lined on both sides of the die. The nozzles are aimed at each area that has to be lubricated.

MaxaMizer controller allows the operator to quickly shut
off nozzles that are not being used. The operator then
has the ability to individually program each of the operating nozzles as to when they will spray and how much lubricant each nozzle will dispense during the cycle of the press. When the dies are changed, inactive nozzles may be repositioned and activated, and active nozzles can be deactivated until needed.