Drilling Milling and Tapping Applications need not only lubrication, they not only lubrication, but they also require cooling and chip removal. The MeterMizer injects lubricant or coolant into the air stream either on a repetative time cycle, programmed schedule or manual command. After the lubricant is dispensed the air remains on to cool the drill or tap and remove chips.
A little lubricant goes a long was in a stamping application. Best suited for smaller stamping applications, The Metermizer is tied into the cycle of the press and dispenses small amounts of lubricant on each cycle of the press or is programmed to dispense the lubricant on a predetermined cycle count. The low pressure air contains the lubricant in a confined area while reducing lubricant consumption.
Use the BasicMeterMizer on Horizontal,Vertical or Cold Saws as well as
abrasive and diamond wheels to extend the life of the tool as well as
improve the finish of the cut. Since the MeterMizer Saw Nozzle surrounds the saw blade, complete lubrication and cooling is achieved. It is the cleanest and most efficient method of lubricating saw blades.
Bearings on overhead conveyors have to be lubricated on a regular
basis to eliminate jerking and grabbing. The MeterMizer is a cost effective way of ensuring precise lubrication without a mess. Set up with a
LSP Controller and the Proximity Sensor picks up the location of the
bearing and sends a signal to the MeterMizer to lubricate the bearings at
just the right time. LSP offers other methods of actuating systems to satisfy specific needs.
